Auto Specialties recommends that these pulleys be installed by a qualified mechanic.

1. JACK UP FRONT OF CAR. PLACE JACK STANDS UNDER PASSENGER SIDE FRAME. PLACE BLOCKS BEHIND REAR WHEELS TO PREVENT VEHICLE FROM ROLLING BACK.

2. REMOVE ENGINE SPLASH GUARD.

3. REMOVE POWER STEERING/WATER PUMP BELT, REMOVE A/C BELT AND THEN REMOVE ALTERNATOR BELT.

4. LOOSEN CRANK BOLT WITH IMPACT.

5. USE PULLER TO REMOVE CRANK PULLEY. IF OIL SEAL IS WORN, REPLACE AT THIS TIME. PUT GREASE ON STEEL SLEEVE ON PULLEY BEFORE INSTALLATION. THIS WILL LUBRICATE OIL SEAL.

6. PLACE NEW CRANK PULLEY ON. TIGHTEN TO 85 FT/LBS.

7. REPEAT STEPS IN REVERSE ORDER.

INSTALL NEW GATES BELT (OR EQUIVALENT) FOR PART NO. 331070:
ALTERNATOR BELT: K040292
PS/WP BELT: K030384
A/C BELT: RETAINS STOCK BELT

FOR PART NO. 331080 INSTALL NEW GATES BELT:
FAN/ALT: K040350
POWER STEERING USES STOCK BELT
A/C USES STOCK BELT